Set of 10 shims for the wrist assembly.
5 - 56548010
5 - 56548070

6 Retaining Clips, C Clips.

5 Retaining rings, medium.

5 Retaining ring, small.

5 Retaining rings, large.

3 complete sets of screws that mount the Negator (Drum) Bracket to the manipulator.

Turnbuckle End, Right Hand, includes locknut. For standard 3/64 cable.

Turnbuckle End, Left Hand, includes locknut. For standard 3/64 cable.

Turnbuckle Barrel. This is the center piece for the cable turnbuckles.

6 Telemanipulator mounting bolts, metric.

Complete set of 4 Stop bolts for a set of manipulators.

Seals the X Bearing from the outside of the Manipulator.

This includes 20 O rings for the lower boot. These go over the top of the boot and into the machined groove on the piece the finger attaches to. A must for hot cells with sophisticated ventilation and pressure systems like Tema and Comecer have. You may also be interested in our Lower booting seal kit. Look for 89631141 Seal Kit.

One pair of Mounting Gaskets

Wrist sprocket for a chain wrist assembly. Also includes bearing and spacers.

Set of four 3/32 cable Right Hand turnbuckles with lock nut included.

Wrist Assembly Shafts, Set of 10.

Complete Turnbuckle Assembly. This gives you all the parts needed to make a fully adjustable cable connection.

Complete set of tong pins and retaining rings for a tong assembly, uses 56508060 retaining rings, 89631066 and 89631072 shafts.

Parralel link, outer, universal, for chain or cable equipped manipulators.

Parralel link, Inner, universal, for chain or cable equipped manipulators.

Complete set of tong springs.

Set of 4 Tong Springs Inner.

Set of 4 Tong Springs Outer.

Spring Bracket with bushings and screws.

Mounting Block with all hardware.

Lockout Shaft with wing nuts, spacers and set screws.

Stop Assembly, universal, for either the inner or outer side of the manipulator.

Set of 4 Azimuth Rotate Bearings.

Wrist cable with ball and LH fittings. Please email us with your telemanipulator model number when ordering this item.